Ball Bearing replacement Märklin Gauge 1 motor
Miscellaneous Items
Ball Bearing replacement Märklin Gauge 1 motor
G-Gauge NYC Diesel with sound in A-B-A consist.
Märklin Turn Table (Drehscheibe) 7186:
Three additional exits (on the bottom) for another round house.
Conversion of H0 motor shields with ball bearings.
ROCO 4163A (Köf III)
Long time project started by Jacques Vuye to convert from 2 rail
to 3 rail. I did several modifications to
make more room for the slider. It runs great on C track but on K track the loco
gets lifted up at the
turnouts by the higher center studs and causes conductivity problems.
A tiny 2 rail HO Diesel was digitized with head and interior lights.
Märklin R880 - before ...
... and after the restauration.
Märklin 456/1 "Pfeifenhaus"
Swiss double loco in G-gauge with 4 motors and sound.
Click here for the whole story...
------------------------------------------------------------------------------------------------------------------------------
The Märklin Zeppelin 3077
Converted to digital with 2 ESU LokPilot V3.0 decoder.
The propeller motor is a DC motor and needs a lot of power.
Drive motor is a High Efficiency Propulsion 5 pole motor.
A tiny jumper connector to isolate decoder from each other
for programming.
-----------------------------------------------------------------------------------------------------------------------------
M-Track turnout with Viessmann 5231 decoder.
LED installed in Lantern.
Flexible catenary segment (188mm, extractable from 183 to
196mm)
for modular layouts.
High Efficiency Propulsion Motor with Ball Bearing in a Märklin Turn Table
7186
Westmodel Prussian T16.0 on a Fleischmann T 16.1 chassis, now equipped
with a ESU LokSound mfx decoder and modified to run on 3 rails.